NAVIGATOR TXB Evolution is the new tool that TEXA designed and developed specifically for the BIKE and MARINE diagnosis environments.
It’s hardware features make it compatible with all the current protocols for both environments and its integrated 16-pin CPC connector allows the use of all the diagnostic cables. It is extremely powerful, equipped with a 16 MBit SRAM and an 8 GBit NAND FLASH storage memory; these are very important features as they allow the mechanic to manage the map files easily.
The supported CAN standards include the CAN single wire management and an extra CAN controller for the diagnosis on more than one network.
PARAMETER RECORDING WHILE MOVING
NAVIGATOR TXB Evolution allows you to record the diagnostic session in “Dynamic Tests” mode, that is while the vehicle or boat is moving in order to identify specific problems that otherwise would not be detected in the workshop.
The interface will recreate a complete outline of the situation in which the fault occurred, supplying important elements for the analysis of the problem in order to identify the causes of the fault and be able to repair the vehicle once it returns to the workshop.
Processor: CORTEX M3 STM32F103ZG 72 MHz, FLASH 1024 KBytes, SRAM 96 KBytes SRAM memory:16 MBits organized in 1024K x 16 bits NAND Flash memory: 8 GBit on an 8-bit bus Vehicle battery: 12VDC and 24VDC system management External power supply: 8 ÷ 32 V USB communication:virtual RS232 via USB 2.0 Device Wireless connection: Bluetooth class1 (30 m) Electronic switch: 2-way, 13 independent positions Diagnostic connector:16-pin CPC
Visible warnings:1 green/red LED, 1 blue LED
12 V consumption: < 200 mA 24 V consumption: < 100 mA
Operating temperature: 0 ÷ 50 °C Storage temperature: – 20 ÷ 60 °C
Operating moisture:10% ÷ 80% without condensation
Supported protocols:
Blink codes
K, L (with current protection 100 mA), ISO9141-2, ISO14230